Description
A scratched or hazed visor scatters light, and you notice it most riding into low sun. This is a fresh aftermarket replacement visor cut for your KYT, so you get a clean, undistorted view of the road back.
Which helmets does this fit?
This replacement visor is matched to these models:
The helmet model name is printed inside the chin bar, under the lining or on the strap label. If yours isn’t listed, check the visor finder — visors are model-specific and a part from a neighbouring model usually won’t clip in.
Which tint should I choose?
- Clear — The everyday choice. Full visibility day or night, and the safe default if you only buy one.
- Deep Black — Sunglasses-level tint. It transmits too little light to be legal for road use in the UK — track and off-road only. Not for night use.
- Revo Clear Red, Revo Clear Blue — A light mirrored finish. Cuts glare and hides your eyes without going as dark as a full mirror. Like all mirrored finishes it transmits too little light to be legal for road use in the UK — track and off-road only.
- Silver, Revo Deep Red, Revo Deep Blue — A mirrored finish. Cuts glare hard and hides your eyes. Mirrored and iridium finishes transmit too little light to be legal for road use in the UK, day or night — treat them as off-road, track and closed-course choices.
Every tint listed here is made for this exact visor aperture, so whichever you pick it clips into the same fitting.
How do I fit it?
Open the visor fully, release the side mechanism on each side, lift the old visor away and clip the new one in until it clicks. It takes a couple of minutes and needs no tools. Peel the protective film off both sides before your first ride.
Is this legal on the road?
What decides it is the approval marking on the individual visor — a BS 4110 grade with an approved certification mark, or an ECE 22.05 approval — not the tint name. These are unbranded aftermarket visors and we cannot confirm the marking on any individual item, so we do not offer them as authorised for road use. Check the marking on the visor you receive. Dark smoke, mirrored and iridium finishes transmit too little light to be legal for road use in the UK, and are a bad idea at night whatever the local rule says — treat them as off-road, track and closed-course daytime choices. This is general guidance, not legal advice — check what applies where you ride.
Shipping and returns
Free tracked shipping to the UK, USA and Europe. Delivery estimates are shown at checkout. If it’s not right, you have 30 days to send it back — see our returns policy.
Aftermarket part, not OEM. KYT model names indicate fitment compatibility only — we are not affiliated with or endorsed by KYT. Confirm your exact model before ordering.
Very clear lens, no defects. Secure accurate fit. A tight fit that requires a little persistence to fit. I used a small screwdriver to help move the catch at the helmet hinge for clearance of the visor lug. Start with the first lug at the edge of the visor, then align the second lug while pushing the catch out of the way with a small lever, then a firm or sharp push to snap the visor into the hinge. The second hinge was much easier. You could file the lug 0.5mm but I didn't find it necessary. Extends the life of the helmet. Just wish they had matching cheek pads.
fabulous! perfect on the suomy tcx pro!
Material used is ok and not defective. Vision looks clear and not wavy
Perfect for the KYT NZ Race.